Alinco DJ-X11E Wide Band Communications Receiver

€359,00

Wide Band Communications Receiver DJ-X11E

Features:

2VFO simultaneous RX
Main-band coverage: 0.05?`1,299.99995MHz all mode AM/FM/WFM/SSB/CW (BFO for SSB/CW receive. An external antenna required for practical HF monitoring. Internal bar antenna for AM broadcast reception and earphone antenna feature inclusive.)
Sub-band coverage: VHF:118?`171MHz/UHF:336?`470MHz in AM/NFM
1200 memory channels with adjustable memory banks using utility freeware (optional PC cable required)
IQ signal and Discriminator output features: DJ-X11 has an IQ signal output that can be used with 3rd-party software to operate as a SDR. 10.7MHz IF discriminator signal can be used with other receiver-related software available on the net such as AIS-plotting.
Voice-guidance system reads entering/entered frequency in English
Easy-to-use twin dials
Pocket size unit measures 61 (W) x 106 (H) x 38 (D) mm / 2.4 (W) x 4.17 (H) x 1.50 (D) in (without projections)
Rigged Polycarbonate body with rubber protectors
Selectable tuning steps: 0.05/0.1/1/5/6.25/8.33/9/10/12.5/15/20/25/30/50/100/125/150/200/500kHz/1MHz
Various scan modes: Preset, programmed, memory, VFO and tone scan
3 selectable scan speeds (VFO: 25ch/s, 33ch/s, 100ch/s, Memory: 4.5ch/s, 8.3ch/s, 20ch/s)
TSQ and DCS decode
Wire remote-control using optional EDS-12
Long-lasting 1800mAh Li-Ion battery pack provides nearly 15 hours of operation at full audio output in a single RX mode
1200 Alphanumeric (up to 16 characters) memory channels
Additional 100 memory channels are available for each Dual-mode memory, Search-pass, Priority monitoring and Programmed Scanning pairs
Large, brightly illuminated full dot-matrix LCD and keypads
Dual channel-scope (Alinco's patented spectrum-analyzer alike feature)
Frequency counter and flash tune
"Bug detector" function searches for hidden transmitters
Illuminated keypad for comfortable operation
Standard Drop-in charger fully charges empty EBP-74 in 4 hours
RF gain and attenuator for both main/sub VFOs
Analog inversion-scramble decoder

Specifications

Receiver range:	Main VFO 0.05 - 1299.99995 MHz in All available modes / Sub VFO 118 - 170.995MHz & 336 - 469.995MHz in AM/FM (Cellular frequencies 824.000 - 849.995MHz, 869.000 - 894.995MHz blocked on T models. EGR model receives Ham and Broadcast bands only. 225 - 335.995 MHz in AM/FM may be usable although out of specification and warranty)
Mode:	FM,WFM,AM,SSB(USB/LSB),CW(CU/CL)
Antenna Impedance:	50 ohms (SMA)
Supply voltage:	DC 3.7V (EBP-74) / DC 4.5V (EDH-33) / DC 5.4V - 6.0V (external regulated source) negative ground
Current consumption:	approx.130mA Mono band / 180mA Dual band
Temperature range:	-10 to +60 dig C (+14 to +140 dig F)
Frequency stability:	-7 to +3ppm(-10 to +60 dig C)(+14 to +140 dig F)
Dimension without projection:	61 (W) x 106 (H) x 38 (D) mm / 2.4 (W) x 4.17 (H) x 1.50 (D)
Weight:	Approx.235g / 8.29 oz (Ant.& EBP-74 inclusive)
Receiver:	Triple-conversion super heterodyne AM/SSB/CW/FM in Main VFO / Double-conversion super heterodyne AM/FM in Sub VFO and WFM in Main VFO
Selectivity:	SSB/CW -6dB: 2kHz or more -50dB : 7.5kHz or less, AM/FM -6dB : 12kHz or more -60dB : 35kHz or less, WFM -6dB : 180kHz ?}40kHz -20dB : 470kHz or less
Sensitivity (typical value within the band: 10dB S/N:AM/SSB/CW 12dBSINAD:FM/WFM):	Main-band: 0.050~0.531MHz (AM) 5dBu 0.531~1.62MHz (AM) 2dBu 1.62~76MHz (AM) -5dBu 1.62~76MHz (SSB,CW) -10dBu 1.62~76MHz (FM) -15dBu 76~108MHz (WFM) -3dBu 108~136MHz (AM) -6dBu 136~174MHz (FM) -14dBu 175~221.75MHz (WFM) -6dBu 221.8~336MHz (AM) 0dBu 336~475.75MHz (FM) -13dBu 475.75~770MHz (WFM) -13dBu 770~1260MHz (FM) -9dBu 1260~1300MHz (FM) -6dBu Sub-band: 118~136MHz (AM) -3dBu 136~170MHz (FM) -14dBu 336~470MHz (FM) -14dBu *225~335.995 MHz in AM/FM may be usable although out of specification and warranty. Sensitivity is better closer to 336MHz. This band is closed at the default setting,
Audio Output power:	More than 100mW (8ohm)

Made in Japan.